AWAN 3886 Server Installation and Configuration Guide

Installing and Configuring AWAN 3886 Servers
AWAN 3886 Server Installation and Configuration Guide—427428-006
2-12
Use the INITIALIZE Command to Update the Flash
RAM
The following diagram shows the sequence of power-up codes for an AWAN 3886
successful boot:
For more information on status and error codes displayed while loading the Flash,
see Table 3-4, Seven-Segment LED Display and Codes, on page 3-6.
4. Check the status of the Flash RAM card by using the SHOW MEMORY
CONFIGURATION command as follows:
Local> show memory configuration
Example 2-3 shows the status that is displayed. (Boldfaced text indicates
emphasis.) The Flash RAM is installed.
As you can see, the Flash RAM is installed. The network load image, or Flash file,
is displayed as WWENG2. Note also the load image size and the software version
number. For more information on the INITIALIZE and SHOW MEMORY
commands, see the Network Access Server Management or Network Access
Server Commands
manuals on the NPIL CD or on the DNPG CD under “Docs.”
5. Use SHOW AWAN to verify that the AWAN features are enabled and that a new
file version is indicated. Boldface lettering is used to show AWAN features
enabled and to show the software version and date.
Local>SHOW AWAN
Example 2-3. Status from SHOW MEMORY CONFIGURATION Command
Dynamic RAM: 4M bytes
Non-Volatile RAM: 32K bytes
Flash RAM:
Installed: Yes
Total size: 4M bytes
Boot block: Valid
Load image:
Name: WWENG2
Size: 1756960 bytes
Version: Network Access SW V02.4. BL50
d-E-d-b-H-4-b-5- rotating figure 8
OK LED light a steady on