AWAN 3886 Server Installation and Configuration Guide

Installing and Configuring AWAN 3886 Servers
AWAN 3886 Server Installation and Configuration Guide—427428-006
2-13
Use the INITIALIZE Command to Update the Flash
RAM
6. Shut down ASL. Wait 10 seconds. Power the AWAN server off, then on, to verify
that the flash file is correct. Note the local messages on the console port.
7. Use SHOW AWAN again to verify the new file version. Example 2-6 shows the
AWAN software build (224) and the VPROC version (T0484 28Jan2002). AWAN
6530 features are enabled. (Boldface lettering is used for emphasis.)
Example 2-6. SHOW AWAN
Local> SHOW AWAN
AWAN Features Enabled
Hardware Model 3886-16
Software build 224
Vproc T0484 28Jan2002
CTRACE Not active
Config resets None
If the Flash RAM Initialization Fails
If you see the following message when issuing a SHOW AWAN command, the Flash
RAM initialization has failed:
In Example 2-7, the 6530 features are not enabled. However, the base-product
features are enabled.
Example 2-4. Status from SHOW AWAN
Local> SHOW AWAN
AWAN Features Enabled
Hardware Model 3886-16
Software build 224
Vproc T0484 28Jan2002
CTRACE Not active
Config resets None
Example 2-5. Local Messages on the Console Port
Console Port - normal reboot, no config resets
Local -090- 3886-16 AWAN software build 224 vproc T0484 28Jan2002
Local -040- Initialization complete
Local -093- Set Server Console Port None
Example 2-7. SHOW AWAN Status: Flash RAM Initialization Failed
Local>SHOW AWAN
Local -097- AWAN features not available in this configuration