AWAN 3886 Server Installation and Configuration Guide

Installing and Configuring AWAN 3886 Servers
AWAN 3886 Server Installation and Configuration Guide—427428-006
2-16
Step 3: Install ASL and ASM
9. Initiate the reboot, download, and reprogramming of the Flash RAM card:
Local>INIT DELAY 0 FROM ETHER UPDATE FLASH
After 5-10 minutes the AWAN will be running on the new software. See Table 3-4,
Seven-Segment LED Display and Codes, on page 3-6.
10. Verify the new software version by using the CLI SHOW AWAN command. (See
Example 2-4 on page 2-13).
11. Power cycle the AWAN, with the TFTP server down, to further verify that the Flash
RAM card is properly updated. Use SHOW AWAN to confirm that the new version
is running.
Information about installing ASL or ASM can be found in Step 4: Use ASL to Set MAC
and IP Addresses on page 2-17.
Step 3: Install ASL and ASM
If you are upgrading to a new DNAS software version, see 3886-6530 Flash RAM
Code (Gemxxx) on page 1-21.
To install the Access Server Manager (ASM) and the Access Server Loader (ASL), do
the following steps:
1. Quit all unnecessary applications.
2. Insert the CD labelled “DECserver Network Access Software V2.x Multi-OS.” For
DECservers 716 and 732, insert the CD ROM in an available drive and run:
X:\DNAS\WIN95NT\SETUP.EXE
where X: is the drive containing the CD ROM.
3. To install the Access Server Manager (ASM) and the Access Server Loader (ASL),
make sure that you choose the appropriate Windows configuration, then follow the
installation prompts.
The necessary files, including the Flash image file, are copied to your hard disk in
the Digital folder under Programs.
4. You may have to restart your PC after installation is complete.