AWAN 3886 Server Installation and Configuration Guide

Installing and Configuring AWAN 3886 Servers
AWAN 3886 Server Installation and Configuration Guide—427428-006
2-22
Step 6: Configure Telnet Listener for Printers from
the CLI
3. Enter the subnet mask for your network by typing:
Local>cha internet mask subnet
4. Verify the subnet mask by typing:
Local>show internet
5. Enter the IP address by typing:
Local>cha internet addr IP_address
6. Verify the address by typing:
Local>show internet
7. Enter the gateway IP address by typing:
Local>cha internet gateway gateway_address
8. Verify the gateway by typing:
Local>show internet gateway
If connected to a network, try a ping to a known address. Try an address on the
local network first, then try more remote addresses that require routing. For
example:
Local>ping IP_address
Step 6: Configure Telnet Listener for Printers
from the CLI
You must set up the Telnet Listener for printers from the CLI prompt. You cannot use
the client DNAS software. The following example is for configuring asynchronous port
7 on TCP port 2007. Boldface lettering is used to emphasize the port number.
On the Local> terminal, enter the following commands to change the Telnet Listener
entries:
Local> change telnet listener 2007 port 7
Local> change telnet listener 2007 connections enabled
The port number must match the value entered in the FASTCNFG file.