AWAN 3886 Server Installation and Configuration Guide

Installing and Configuring AWAN 3886 Servers
AWAN 3886 Server Installation and Configuration Guide—427428-006
2-23
Step 7: Configure Printer Files on the HP NonStop
Host
Step 7: Configure Printer Files on the
HP NonStop Host
Required: The NonStop Kernel FASTPTCP ABF, or later.
Recommended: FASTPTCP, using a Telnet connection and TTAP printers.
The following paragraphs describe how to configure your AWAN 3886 and
FASTPTCP.
For complete information about editing and creating a SPLCONF file, refer to the
Guardian User’s Guide and the Spooler FASTP Print Processes Manual. Spoolcom
commands are described in the Spooler Utilities Reference Manual, Spooler Plus
Utilities Reference Manual,
and Spooler FASTP Network Print Processes Manual.
Configure the FASTCNFG File
Example 2-9 shows an example of a FASTCNFG file that contains entries for two 3886
AWAN-connected serial printers. (Boldface lettering is used for emphasis.)
The ADDRESS value must match the IP address of the AWAN unit. The PORT value
must match the value specified in the AWAN Telnet Listener.
Example 2-9. FASTCNFG File
DEVICE $PRT1 !dumb serial printer thru AWAN 16 port 2
CONTYPE = TCP/IP-TELNET
PROTOCOL = NONE
ADDRESS = 172.17.201.155
PORT = 2002
TIMEOUT = 1800
NOTHINGMARK = NO
TCP/IP-A = $ZTC0
TCP/IP-B = $ZTC1
DEVICE $PRT2 !TTAP PRINTER thru AWAN 16 port 3
CONTYPE = TCP/IP-TELNET
PROTOCOL = TTAP
ADDRESS = 172.17.201.155
PORT = 2003
TIMEOUT = 100
NOTHINGMARK = NO
TCP/IP-A = $ZTC0
TCP/IP-B = $ZTC1