AWAN 3886 Server Installation and Configuration Guide

Installing and Configuring AWAN 3886 Servers
AWAN 3886 Server Installation and Configuration Guide—427428-006
2-28
Understanding the AWAN 3886 T6530 Port Defaults
For example, with autoconnect enabled and preferred service enabled, the end user
would see a welcome screen similar to Example 2-11:
Example 2-11. Preferred Service Enabled
WELCOME TO L01D [PORT $ZB01D #23 WINDOW $ZT01D.#PTGBU2Z]
TELSERV - T9553D40 - (28MAY99) - (IPMADB)
Available Services:
TACL EXIT
Enter Choice> TACL 1>
To set autobaud disabled and autoconnect enabled, using the defaults, you can enter
the following AWAN commands for port 2 as shown in Example 2-12 on page 2-28.
Then, assuming a typical 6530 asynchronous settings and a typical IP address setting
for the NonStop Kernel host, enter the following AWAN commands at the CLI for
port 2:
The following paragraphs describe the CLI commands, including defaults.
Understanding the AWAN 3886 T6530 Port Defaults
The following commands are T6530 emulation protocol defaults for AWAN servers.
These commands are entered at the CLI prompt.
Define Port n Awan T6530
Define Port n Access Local
Define Port n Default Protocol Telnet
Define Port n Autobaud Enabled
Define Port n Autoconnect Disabled
Example 2-12. Setting Autobaud Disabled, Autoconnect Enabled
Local>define port 2 awan t6530
Local>define port 2 access local
Local>define port 2 default protocol telnet
Local>define port 2 username awan
Local>define port 2 signal control disabled
Local>define port 2 flow disabled
Example 2-13. Setting Autobaud Disabled, Autoconnect Enabled (continued)
Local>define port 2 autobaud disabled
Local>define port 2 speed 19200 parity even char 7
Local>define port 2 autoconnect enabled
Local>define port 2 preferred 10.2.3.4 node TACL