AWAN 3886 Server Installation and Configuration Guide

Installing and Configuring AWAN 3886 Servers
AWAN 3886 Server Installation and Configuration Guide—427428-006
2-30
Understanding the AWAN 3886 T6530 Port Defaults
define port n autoconnect
disabled
define port n preferred
none
(Default) After port login, a Local prompt
appears. The end user may enter CLI
commands to configure or manage the
AWAN, or may manually enter a
CONNECT or TELNET command to
establish a session to a NonStop Telserv
host.
define port n autoconnect
enabled
After port login, a CONNECT is
automatically performed to the preferred
service. If Preferred is None, then
Autoconnect has no effect.
Autoconnect permits transparent
operation, allowing end users to minimize
or eliminate AWAN interactions. This setup
provides much the same appearance as
direct connections to older asynchronous
controllers.
See define port n preferred.
define port n preferred When autoconnect is enabled, or when a
CONNECT command without parameters
is entered from a Local prompt, then the
port preferred settings are used.
Combinations and definitions are
described below. The following definitions
apply:
•
host: The address of the NSK Telserv
host, either in dotted form
( e . g . 12 8 . 1 .2 . 3) o r a D N S n am e
(e.g. SYS1.COMPANY.COM)
•
service: A Telserv service name that
usually shows at the Telserv
welcome menu, for example, TACL.
Alternatively, the name of a Telserv SU
window, with underscore (_)
used instead of the pound sign (#); for
example, _WIN23.
•
port: A decimal TCP port number used
when the NonStop Kernel Telserv
process is listening at a non-standard
TCP port number. The default Telnet
port 23 is assumed.