AWAN 3886 Server Installation and Configuration Guide

Installing and Configuring AWAN 3886 Servers
AWAN 3886 Server Installation and Configuration Guide—427428-006
2-31
Step 10: Configure the Modem Using ASM
(Optional)
Step 10: Configure the Modem Using ASM
(Optional)
The following text outlines the steps for selecting and configuring a modem.
When you use ASM to configure a modem, the permanent settings are updated in the
modem’s NVRAM. Thus, you only need to perform this configuration once: Only when
a new modem is installed or when the modem itself has been reconfigured.
Modem straps are to be configured to accept AT commands and display result
codes.You want to set the modem speed to 115200, or the fastest speed the modem
will handle.
define port n preferred
none
Clears any previously entered Preferred
settings.
define port n preferred
host
Connection is made to host at the
standard Telnet TCP port 23. The user
must then enter the Telserv service or
window name.
define port n preferred
host dest port
Connection is made to host at TCP port
port. The user must then enter the Telserv
service or window name.
define port n preferred
host node service
Connection is made to host at the
standard Telnet TCP port 23; service is
automatically provided as input to the
Telserv prompt, selecting the specified
Telserv service or window.
define port n preferred
host node service dest
port
Connection is made to host at TCP port
port; service is automatically provided as
input to the Telserv prompt, selecting the
specified Telserv service or window.
define port n username
awan
The port username field is required for a
port login. If the username is not defined,
then the prompt Enter username>
appears on every port login, requiring the
entry of any non-blank value.
define port n flow
disabled
6530 terminals do not support CTS or
XON flow control; instead 6530 terminals
support higher-level protocol methods.
Setting port flow causes either partial or
total inoperation of 6530.
Note. Steps for Configuring the Modem on page 2-32 describe how to configure the modem,
not the AWAN port.