AWAN 3886 Server Installation and Configuration Guide

Installing and Configuring AWAN 3886 Servers
AWAN 3886 Server Installation and Configuration Guide—427428-006
2-32
Steps for Configuring the Modem
When 6530 support is enabled, the default port settings interfere with ASM modem
configuration. Before using ASM to configure a modem, use CLI commands to change
the following port settings:
Steps for Configuring the Modem
1. To use ASM to configure a modem, certain default port settings must be changed,
as follows:
define port n default protocol LAT
define port n awan ansi
define port n signal control enabled
logout port n
2. Connect your modem to one of the ports on the 3886 AWAN server, and power on
the modem.
3. From the Configuration screen, double-click Ports.
4. Choose Configure.
5. Double-click the port number to select the port to which you attached the modem.
6. Click Configure Modem. The ASM displays the Configure Modem dialog. Using
the down-arrow, select the port number as shown in Figure 2-8.
Figure 2-8. Configure Modem Dialog