AWAN 3886 Server Installation and Configuration Guide

Installing and Configuring AWAN 3886 Servers
AWAN 3886 Server Installation and Configuration Guide—427428-006
2-34
Step 11: Configure a Modem Port Using the CLI
(Optional)
13. Click the Commands tab to set the modem commands. Set the modem commands
and click OK.
14. Click OK to return to the Modem dialog and click Apply to configure the modem. A
window appears, showing the AT commands that are being sent to the modem
along with the modem responses. If this window does not appear, then the modem
has not been configured.
For DECserver 700-08 models with DB25 connectors, use a straight-through modem
cable. For models with RJ45 connectors, use a DM25RJ45 adapter.
The modem should be configured to reset when the DTR signal from the AWAN is
dropped. See Appendix A, Adapters for Cables and Devices for the pin-out for the
DM25RJ45 adapter.
Step 11: Configure a Modem Port Using the
CLI (Optional)
The following text describes how to set up the ports for terminal dial-in using the CLI
command line. You want to set the modem speed to 115200, or the fastest speed the
modem will handle.
1. At the local prompt, enter privileged mode as follows:
Local> set priv
2. Enter the default system password as follows:
Password>system
Figure 2-10. General Tab (Defaults Selected)