AWAN 3886 Server Installation and Configuration Guide

Installing and Configuring AWAN 3886 Servers
AWAN 3886 Server Installation and Configuration Guide—427428-006
2-38
Step 14: Configure Point-to-Point Protocol (PPP)
(Optional)
9. Click the Properties button to display the Port n: Dial-up PPP Configuration dialog
where you configure the Dial-up protocol. In the Dial-up PPP Configuration screen,
do the following:
•
select Flow control.
•
select Hardware RTS/CTS.
•
configure the Port IP address.
•
change Port Speed to 115200.
For port protocols, do the following:
•
select IP
•
clear IPX so that it is blank
•
leave blank Enable dialin.
•
clear AppleTalk so that it is blank
•
select Enable port security
•
select PAP with security realms
10. Select OK, then go back to Port Tab and select OK.
11. For all AWAN 3886-16 and 3886-32 models, after the ASM Configure Port
sequence is completed, enter the following CLI command for the designated port:
Local>Change Port n LCP Passive Enabled