AWAN 3886 Server Installation and Configuration Guide

Troubleshooting AWAN 3886 Servers
AWAN 3886 Server Installation and Configuration Guide—427428-006
3-11
Status: Rotating figure 8, But AWAN Features Not
Enabled Problem: Flash RAM Card is Not Enabled
Status: Rotating figure 8, But AWAN Features Not Enabled
Problem: Flash RAM Card is Not Enabled
AWAN status reported on Port 1:
Using SHOW AWAN:
Local> SHOW AWAN
Local -099- AWAN features not available in this configuration
Table 3-9. Rotating Figure 8, AWAN Features Not Enabled
Problem Solution
Flash RAM card is write-protected. Flash card was write-protected at server
initialization time. To permit detection of AWAN
features, flash must be write-enabled.
Unprotect Flash RAM card and power the AWAN
off and then back on.
LED Indicators Seven-Segment Display
After restoring power the LINK
PULSE LED will be ON very
quickly
Port 1 Error Message
-610-Unknown Flash RAM device ID
detected
Example 3-6. Port 1: Flash RAM Update Failed
Local -901- Initializing DECserver 716 00-00-F8-52-BB-7F FW V7.2-0 HW 1.7
Local -960- Available Memory 4 Mbytes
Local -969- Requesting Specified Software: WWENG2
Local -959- [FLASH] Attempting to locate load image [FLASHRAM]
Local -904- Image load complete
Local -042- Flash RAM update failed
Local -610- Unknown Flash RAM device ID detected
Local -040- Software initialization complete
Network Access SW V2.4 BL50.09 for DS716
(c) Copyright 2000, Digital Networks - All Rights Reserved
Please type HELP if you need assistance
rotating figure 8
OK LED light a steady on
d-E-d-b-H-4-b-5-