Backup and Restore 2 Manual

BRCOM BACKUP Command
Backup and Restore 2 Manual—522696-019
6-31
LISTALL Job Option
Guidelines

If you do not specify this job option, BRCOM automatically assigns a job identifier
and displays it after the job has been started.

You cannot use a job ID if any files exist in $workvolume.jobid.

The job ID cannot be present in the BRJOBS file.
LISTALL Job Option
This job option lists the names of the backed-up objects and objects that cause errors
to an OUT file or a current terminal. OFF is the default.
ON
lists the names of all backed-up objects and the names of the objects that cause
errors.
OFF
lists only the file names associated with error messages to the EMS log.
Guidelines

If you specify LISTALL ON and the OUT job parameter, the list is directed to the
OUT file. If you specify LISTALL ON but omit the OUT job parameter, the list is
directed to your current terminal.

If you do not specify the LISTALL ON job option, the file names associated with
error messages are recorded only in the EMS event log.

Monitor EMS messages. Some messages are only sent as EMS messages, not as
LISTALL output.

If you specify the LISTALL ON job option but omit the OUT job option, the LISTALL
output is directed to your current terminal. The BRCOM prompt does not return
until the job completes unless you press the Break key.
NEEDBOTH Job Option
This job option defines how the backup and restore operation should treat errors during
parallel backup. This job option is valid only for a parallel backup operation (that is,
when two tape devices are specified). The Default is OFF.
LISTALL { ON | OFF }
Note. The parallel backup feature and hence, the NEEDBOTH job option, is supported only on
systems running H06.05 or later H-series RVUs.