Backup and Restore 2 Manual

BRCOM RESTORE Command
Backup and Restore 2 Manual—522696-019
7-24
BRCOM RESTORE Command Syntax
RESTORE job options for the BACKUP and RESTORE utilities (T9074), see
Changed or Unsupported Restore Job Options on page B-6.
config-option
specifies the RESTORE configuration options that you can use to supersede the
configuration option settings in the BRCONFIG file. It is any of:
EMSCOLLECTOR[\node.]$process-name
SERVICECPULIST [processor [, processor ] ]...
SERVICEPRI number
WORKVOLUME devicename
For more information about the default configuration options, see
Managing Configuration Information on page 3-1.
EMSCOLLECTOR [\node.]$process-name
is the collector for EMS messages. If you do not specify an EMS collector, the
messages are sent to the EMS collector as configured in the BRCONFIG file.
SERVICECPULIST [ processor, [processor] ... ]
is a value from 0 through 15 that specifies a list of the processors in which the
DMA starts the Data Service and Tape Service. You must separate each
processor in the list with a comma. If you do not specify any processors, the
services are started as configured in the BRCONFIG file.
SERVICEPRI number
is no value, a value of -1, or a value of 1 through 199 that specifies the priority
at which the DMA starts the Data Service and Tape Service. If you specify -1 or
do not specify a SERVICEPRI, the Data Service and Tape Service are started
at the priority configured in the BRCONFIG file.
WORKVOLUME $valid disk name
is the name of the disk volume on which jobs create their files. If you do not
specify a work volume, the files for each job are created in the work volume
configured in the BRCONFIG file.