Backup and Restore 2 Manual

BRCOM RESTORE Command

Backup and Restore 2 Manual—522696-019

7-25

BRCOM RESTORE Syntax When Using an IN File

The RESTORE command in the IN file must not itself specify the IN run option. If you

specify an IN file, the tape-device-name specified on the command line overrides

the tape-device-name specified in the IN file. For more information, see Using an

IN File on page 4-7. When you are using an IN file, the syntax is:

tape-device-name

is the name of a tape drive. You must specify a tape drive. The tape-device-

name specified on the command line overrides the tape-device-name specified

in the IN file. Backup and Restore 2 does not support virtual tape drives created by

TAPESIM because TAPESIM does not support LBA. Any attempt to get the LBA on

a tape drive created by TAPESIM results in file-system error 2.

run-option

is supported as described in the TACL Reference Manual, except as listed in

Table 7-3 on page 7-23. Any run option that you specify on the command line

overrides a corresponding run option in the IN file.

in-file

is the name of a IN file. You cannot specify any options after the IN run option.

Therefore, you cannot specify job options or configuration options on the command

line.

Restore Objects

Backup and Restore 2 supports these objects:



OSS RESTORE Object on page 7-26



SQL/MX RESTORE Object on page 7-27

RESTORE

tape-device-name

[ , run-option [ , run-option ] ... ] IN in-file