Backup and Restore 2 Manual

BRCOM RESTORE Command
Backup and Restore 2 Manual—522696-019
7-49
RESTOREBKUPSPEC Job Option
resulting in an inconsistent table. Accessing the data from the table can lead to
unpredictable results.

If you explicitly specify any table partitions or index partitions, you must specify
PARTONLY ON.

If you do not specify any table partitions or index partitions, you must not specify
PARTONLY ON.

If you specify PARTONLY ON, you cannot specify SQLDATA OFF or LOCATION.

If you specify the PARTONLY ON job option during a backup operation, you must
also specify PARTONLY ON for the RESTORE command.

The PARTONLY job option is supported only for SQL/MX objects. If you specify
this job option but do not specify any SQL/MX objects, an error occurs.
RESTOREBKUPSPEC Job Option
Use this job option to restore the BRCMD file as the file specified by filename. This
job option has no default value.
filename
is the location to restore the BRCMD file. A fully qualified file name is not required.
Guidelines

If you specify a file name that already exists, RESTORE attempts to overwrite it.

For more information, see Using the BRCMD File on page 4-8.
RESTOREDIR Job Option
Use this job option to restore the BRIC file from tape to disk as the file specified by
filename. This job option has no default value.
filename
is the disk file in which to restore the BRIC. A fully qualified file name is not
required.
Guideline
If you specify a file name that already exists, RESTORE attempts to overwrite it.
RESTOREBKUPSPEC filename
RESTOREDIR filename