Backup and Restore 2 Manual

BRCOM Error Messages
Backup and Restore 2 Manual—522696-019
A-8
Error Messages
2024
Cause. You attempted to perform a BACKUP or RESTORE command that requires
the BRCOM home terminal while another backup or restore operation was already
running from the same BRCOM session. For more information,
see Handling Operations That Use the BRCOM Terminal on page 4-5
Effect. The second command fails. The first operation is unaffected.
Recovery. Retry the command in one of these ways:

Run another BRCOM session on another terminal and try the second command
from that session.

Retry the command from the current session, but specify an alternate output
location.

For commands (Enscribe or SQL/MP) forwarded to the BACKUP and
RESTORE utility (T9074), use the /OUT/ run option to specify an output
location other than the current terminal.

For Backup and Restore 2 commands, use the OUT job option to specify an
output location other than the current terminal.

Retry the BACKUP or RESTORE command (OSS or SQL/MX) from the current
session, but omit the LISTALL and LISTONLY job options.
2026
record-id
is the identifier for the record.
filename
is the name of the file.
Cause. You attempted to perform an operation that needed to lock the record-id
record from the filename file. The record could not be locked because it was already
locked by another process.
Effect. The record cannot be updated, so the operation fails.
Recovery. Retry the operation. If the record remains locked, and this error occurred
on a job record in the BRJOBS file, a problem might exist with the job's DMA process.
If necessary, use the STATUS JOB command to identify that process and then stop it.
Cannot run multiple Backup or Restore operations using the
BRCOM home terminal.
Record record-id in file filename could not be locked. Record
cannot be updated.