Backup and Restore 2 Manual

Comparison With the BACKUP and RESTORE
Utilities
Backup and Restore 2 Manual—522696-019
B-4
Changed or Unsupported Backup Job Options
MSGONLOCK Enscribe
SQL/MP
This option is not supported.
MULTIDRIVE Enscribe
SQL/MP
This option is not supported.
NEEDBOTH Enscribe
SQL/MP
The NEEDBOTH option is
supported only on systems
running H06.05 and later H-
series RVUs.
NOMYID Enscribe
SQL/MP
For OSS, this option has been
replaced by the ALLOWMYID
OFF option. This option is not
supported for SQL/MX.
NOPROMPT Enscribe
SQL/MP
BACKUP and RESTORE
utilities (T9074) run in
waited mode. The
NOPROMPT option
instructs BACKUP or
RESTORE to not prompt
you before beginning to
write on each tape, but to
begin when it detects the
tape drive is ready.
Backup and Restore 2 always
writes to tape without
prompting you. Therefore, this
option is not needed.
NOREWIND Enscribe
SQL/MP
This option has been replaced
by the TAPEDISPOSITION
NOREWIND option.
NOSAFEGUARD Enscribe This option is not supported.
NOSQLDATA SQL/MP This option has been replaced
by the SQLDATA OFF option.
NOT Enscribe
SQL/MP
This option is not supported.
NOUNLOAD Enscribe
SQL/MP
This option has been replaced
by the TAPEDISPOSITION
BOT option.
OPEN Enscribe
SQL/MP
This option is not currently
supported for OSS. However,
this option is supported for
SQL/MX.
PART Enscribe This option is not supported.
PARTIAL Enscribe This option is not supported.
Table B-1. Backup Job Options Not Supported or Changed (page 2 of 3)
Option SQL/MP or Enscribe SQL/MX or OSS