Binder Manual (G06.24+, H06.03+)

BIND Commands
Binder Manual—528613-003
3-68
SHOW Command
AXCEL ENABLE [FROM file-name]
displays the current state, either ON or OFF, of the AXCEL ENABLE attribute for
the current file or file specified in the FROM clause. You can set this attribute with
the CHANGE command. OSS pathnames are accepted.
FILE
displays the name of the current file.
IMPORT
displays the list of imported data blocks specified for the current session. This
command only lists the set of variables explicitly specified in the SET IMPORT
command. The complete import list is not determined until build time.
INFO [FROM file-name]
displays attributes (number of data pages, process subtype, number of code
segments and file segments, system type, Accelerator information, Binder
information, and debugging information) associated with the current Guardian file
or OSS pathname, or the Guardian file or OSS pathname specified in the FROM
clause. The output will include Itanium instruction information if the program has
been translated by OCA and will show the MISALIGN attribute of the object.
MODIFY
displays the current set of modifications established by the MODIFY command. If
code has been modified, the values are displayed in ICODE as well as octal.
OCA ENABLE [ FROM file-name ]
This command shows whether the named TNS object file is allowed to be
translated by OCA, and, if an Itanium instruction region exists, whether its Itanium
instructions can be executed in a translated mode of execution.
RESERVE
displays the reserve settings for each of the four data areas: BELOW64,
PRIMARY, SECONDARY, and EXTENDED.
SELECT
displays the current values for all the SELECT command parameters.
select-param
displays one of the following SELECT command parameters:
CHECK SATISFY
REFER FILESYS
COMPACT FIXUPS