Binder Manual (G06.24+, H06.03+)

Binder Messages
Binder Manual—528613-003
8-20
Error Messages and Warnings
98
Data blocks do not have a code segment number associated with them. Remove the
code segment from the command, and try again.
99
The SUBTYPE value in the SET command must be in the range 0–63.
100
The procedure entry point table can have a maximum of 8160 entries, one for each
entry point. You must restructure the program.
101
You are attempting to bind a large model program with a small model program. This is
not allowed. All code and data blocks included at the same time must be from the
same model.
102
The Binder has failed with a trap; notify your HP representative.
104
The volume name used in PARAM swapvol is not a valid volume name on your
system.
E A space number has been given with a data address
E Illegal SUBTYPE value -- ignored
E More than 8160 entry points on include list:
E Parameter addressing incompatibility
F Fatal trap
W Illegal volume name passed in param swapvol
message -- ignored