Binder Manual (G06.24+, H06.03+)

Binder Messages
Binder Manual—528613-003
8-28
Completion Codes
232
When the build command is issued, Binder applies the modifications from the modify
list. If the requested data block is not currently initialized, it is not modified.
233
Binder abends when the DST table is obsolete.
234
Binder cannot SQL-compile an SQL object file, if the object file is stripped of the Binder
region.
770
Either Binder cannot use the message table \.$SYSTEM.SYSTEM.PDTERROR or the
$SYSTEM.SYSTEM.PDTERROR file does not contain error messages for Binder.
Completion Codes
This subsection lists the completion codes returned by Binder. These codes are
displayed at the end of a Binder process and explain why a process terminated.
W Modify location is uninitialized,target object may not contain new data
F Error encountered during timestamp conversion.
W Cannot SQL compile a stripped object file.
E message table \.$SYSTEM.SYSTEM.PDTERROR
Table 8-1. Binder Completion Codes (page 1 of 2)
Code Meaning
0 The process terminated abnormally. No WARNINGS or ERRORS
were issued.
1 This code can have either of the following meanings:
One or more WARNINGS were issued in a session. Object
file is complete.
One or more ERRORS were issued in a noninteractive
session. Object file is complete.
2 A FATAL ERROR occurred. No object code was produced.