Binder Manual (G06.24+, H06.03+)

BIND Commands
Binder Manual—528613-003
3-2
Summary of Most Commonly Used Commands
For a summary of BIND commands and their syntax, see Section 9, Syntax Summary.
Summary of Most Commonly Used Commands
BIND commands allow a broad range of object file manipulations.
RESET Command 3-44
SATISFY Command 3-47
SELECT Command 3-49
SET Command 3-57
SHOW Command 3-67
STRIP Command 3-75
SYSTEM Command 3-77
VERIFY Command 3-77
VOLUME Command 3-78
Table 3-1. Commonly Used BIND Commands (page 1 of 2)
Command Description
ADD Names the blocks and entry points to include; replaces blocks, entry
points, and any referenced RTDUs, deleting any previous occurrence of
the named item.
BUILD Creates the target file.
CLEAR Deletes input information without building a file.
COMMENT Enters comments.
DELETE Removes block names from the include lists.
DUMP Displays object file contents in ASCII, HEX, ICODE, OCTAL, or
DECIMAL.
FILE Gives a default disk file name for the current file to use for retrieval of
code or data blocks.
INFO Displays information about names on the include, unresolved reference,
and undefined lists.
LIST Selects load maps and object cross-reference listings.
REPLACE Names replacements for code blocks, data blocks, and any referenced
RTDUs already on the include lists.
SELECT Specifies controls for satisfying references or building the target file; also
selects BIND services such as parameter checking or compressing the
code area.
Command Page