COBOL Manual for TNS and TNS/R Programs

Run-Time Diagnostic Messages
HP COBOL Manual for TNS and TNS/R Programs—522555-006
48-27
Message List
44 (none)
Cause. Both of the parameters to an ATAN function were zero. At least one of the
parameters must be nonzero.
Effect. Program behavior is language and application dependent.
Recovery. Modify the program to pass the correct value to the ATAN function.
46 (none)
Cause. The parameter passed to a logarithm function (LOG or LOG10) was less than
or equal to zero. The parameter to a logarithm function must be greater than zero.
Effect. Program behavior is language and application dependent.
Recovery. Modify the program to pass a valid value to the logarithm function.
47 (none)
Cause. The value of the second parameter to the MOD function was zero. The second
parameter to the MOD function must be nonzero.
Effect. Program behavior is language and application dependent.
Recovery. Modify the program to pass a nonzero value to the MOD function.
48 (none)
Cause. Parameters to the exponentiation operator were not acceptable. Given the
expression
x ** y
these parameter combinations produce this message:
x = 0 and y is not 0
x < 0 and y is not an integral value
Effect. Program behavior is language and application dependent.
Recovery. Modify the program to pass values that do not violate the above
combinations.
Arctan domain fault
Logarithm function domain fault
Modulo function domain fault
Exponentiation domain fault