CORBA 2.3.3 Getting Started Guide (NonStop CORBA 2.3.3+)

Chapter 3. Installing NonStop CORBA
Prev Next
Chapter 3. Installing NonStop CORBA
Table of Contents
Installation Overview
Before You Begin the Installation
Performing the Installation
Hardware and Software Requirements
Check for Previously Installed Products
Perform Subsystem Resource Cleanup
Install NonStop CORBA on the Host System
Run the IPSetup Program
Run the NonStop CORBA OSS Installer Setup Program
Host Installation Installer Wizard
Install NonStop CORBA SDK Over NonStop EJB
Before You Begin Installing NonStop CORBA Over NonStop EJB
Ensure the ORB.properties Include CORBA and EJB Properties
Create a Superset of ORB.properties
Install NonStop CORBA over NonStop EJB
Install the NonStop Distributed Component Console on the PC
Install JORB Lite on the PC
Start NonStop CORBA Server Processes on the Host System
Alternative Installation Method
Run the Install Script
Sample Script Run
Installation Overview
To install the NonStop CORBA product you use installers running on your PC to place the NonStop CORBA components
on your Compaq NonStop Himalaya S-Series system. As an alternative you can install directly on the NonStop Himalaya
system through the OSS environment. Both installation methods are discussed in this section. After you complete
installation on the NonStop Himalaya system, you use the Compaq NonStop" Distributed Component Console installer to
install the console on your PC. You may also install additional optional software on your PC. When installation is complete
you run the console software to start the NonStop Services for CORBA processes. Sample programs can then be run to
verify your installation.
Before You Begin the Installation
Review the readme file on the product CD to make sure you have the correct version for all products installed on your
NonStop Himalaya S-Series system.
●
Make sure your site meets the minimum hardware and software requirements, as indicated in Hardware and Software●