CORBA 2.3.7 README

Installation Subvolumes: (A) IPSetup only, or (B) IPSetup in
conjunction with DSM/SCM.
7. Follow the pre-installation instructions in Section II below, if
any, before continuing to Step 8.
8. Run IPSetup to place and install (move NonStop Kernel files to
correct ISVs) this product. If TCP/IP and FTP are unavailable, or
if you have problems with automatic file placement, use the
instructions in the IPSetup User Guide section
"Manual Software Placement Using the IPSetup TACL Program" to
manually place NonStop Kernel files.
This product contains both NonStop Kernel components and workstation
components. You must place each component type separately. To
restart the installation program after placing the first component
type, click SETUP.EXE in the root directory.
IMPORTANT: Always reinstall this product after installing
a Site Update Tape (SUT).
Installing a SUT using the Install product can result in
overwriting this Independent Product with older versions of
software. This problem does not occur when using DSM/SCM
to install SUTs.
9. Follow the post-installation instructions in Section III below, if
any, after using IPSetup to place and install this product.
II. Pre-Installation Instructions
Prepare to run IPSetup by performing the following steps:
1. If you have an existing NonStop CORBA 2.3 installation, stop all
NonStop CORBA 2.3 applications and subsystem.
Discussion: Eliminates file conflicts with the earlier
version NonStop CORBA 2.3 installations.
When updating the ISVs, IPSetup attempts to purge existing
files in the ISV during processing. If a NonStop CORBA 2.3
application is running, IPSetup is not able to purge files,
such as NSDSRL and terminates.
2. Ensure that you, the installation user, are not listed in
$SYSTEM.ZTCPIP.FTPUSERS.
Discussion: If you try to install products using IPSetup and
your user ID is listed in $SYSTEM.ZTCPIP.FTPUSERS, the
installation fails at the point where IPSetup tries to transfer
(ftp command) the files from the workstation to the NonStop
system. This failure occurs in a typical situation when S-series
you install the product using the super.super ID and, for common
security reasons, the super.super ID is forbidden ftp access.
III. Post-Installation Instructions
1. Invoke the INSTALL^TEMPLATES TACL macro to install the ZDOMTMPL EMS
template files contained on the CD. This TACL macro and
file:///C|/Corba Readmes/ReadmeCORBA23u7.txt
file:///C|/Corba Readmes/ReadmeCORBA23u7.txt (2 of 9) [4/27/2004 11:42:26 AM]