CORBA 2.6 Getting Started Guide for Java

Note: Copy this file to your PC after each NonStop CORBA reconfiguration on the NonStop system.

Modify jorblite-dir\lib\lite.dbm so that the host_name entry contains the host-name of your

PC (the host from where you run JORB Lite).

When you unpack JORB Lite, it installs the file env.bat into the etc subdirectory. The installer also sets various

environmental variables used by your JORB Lite setup. You may use the env.bat file to manually set the

variables, which may need to be modified for your installation. Make sure that the following default environment

variables set in this file refer to the correct directories on your PC system:

JORB Lite Environmental Variable Setting

Variable Default Setting Description

JORBLITE_HOME c:\jorblite

Root directory of your JORB Lite installation.

JAVA_HOME c:\jdk 1.3.1

Root directory of your JDK installation. Assumes that you have the 1.3.1

JDK installed.

For example, if you install JORB Lite into a directory other than c:\jorblite, you will have to modify the

file etc\env.bat so that the JORBLITE_HOME environment variables reference the correct JORB Lite root

directory.

The JORB Lite Directory Structure

When you install JORB Lite, the installation process creates the following directory structure under your base

JORB Lite directory:

The JORB Lite Directory Structure

+--bin

+--docs

| +--javapubs

| +--javadocs

+--etc

+--idl

+--javasamples

| +--bank

| +--calc

| +--event_service

| +--ins

| +--jpathsend

| +--jts_bank

| +--stack

| +--stack-obv

| +--stack-tie

| +--stock

| +--stock-dynamic