CORBA 2.6.1 Administration Guide

Server is 0 through 4095.
Static
Servers
Number of static servers, which are processes that are started automatically when the TS/MP environment starts.
(Dynamic servers are started as needed by the PATHMON process.) The range of values is 0 through 4095. The
value must not exceed the value of the Maximum servers field. For better performance, the number of static servers
should be close to or equal to the value for Maximum servers.
Process
Name
Name of the server process. If you do not choose a name, the system assigns one when the process starts.
Processors List of CPUs in which server processes can run. Separate the CPU numbers with commas; for example, 1,2,5. If you
do not specify a list of CPUs, the system runs server processes in any available CPU. Specifying certain CPUs
requires the system to use only the CPUs in the list.
Process
priority
Priority at which the server process is run. The range of values is 1 through 199, the highest priority being 199.
Autorestart
attempts
Number of attempts to restart the server process, in the event of its abnormal termination. The maximum number is
32767.
Create
delay
Length of time in microseconds requests are queued while a LINKMON process waits for a server (static or dynamic)
to become available. When this time is exceeded, the PATHMON process creates a dynamic server to process
requests. The maximum time is 18 hours.
Delete
delay
Length of time in microseconds the PATHMON process waits before deleting unused dynamic server processes. The
maximum time is 18 hours.
Max links Maximum number of links that a server process in a server pool can have to all LINKMON processes on the host
system. For example, if the Link depth field is set to 10 and there are 3 CPUs in the host system, set the Max links
field to 30 to avoid queueing requests at the server process. While a server process is processing a request, the
maximum number of queued requests is the value of the Max links field minus 1. The range of Max links values is 0
through 4095.
Link depth Number of concurrent links allowed from a LINKMON process to a particular server process in a server pool. The
range of values is 1 through 255. Set the value of Link depth to be less than or equal to the value of Max links. If
Max links is 0, use the default value of 1 for Link depth.
Send
timeout
Length of time in microseconds the LINKMON process waits for a server process I/O operation to complete. The
maximum time is 18 hours.
Log file Name of the file to which server process output is written.
Event Service Properties
Basic Configuration
Server Configuration Options
Troubleshooting Options
Basic Configuration
Property Description
Host address IP address of the host system on which the server is listening. The host systems available in the drop-down list
are those managed by the selected TCP process.
Port number Port number on the host system to which the server is listening. The port number cannot be used by any other
process on the host system.
TCP process Name of the TCP process that is managing the selected host address. One TCP process can manage multiple
host addresses. TCP processes can be spread across CPUs for load balancing. If the "Use Parallel Library
TCP/IP" check box is checked, specify a TCP process that is enabled for Parallel Library TCP/IP.
Initially create Select either Event Channel Factory (to initially create an event channel factory) or Event Channel (to initially
create a single event channel). Event Channel Factory is the typical choice.
Register
channel or
factory in
Naming Service
Recommended: Leave this box checked so that applications can find the event channel or event factory in the
Naming Service.
Name Name that is associated with the event channel or event channel factory in the Naming Service.