CP6100 Configuration and Management Manual

Managing CP6100 Using the Subsystem
Control Facility (SCF)
CP6100 Configuration and Management Manual—426741-003
8-7
Wild-Card Support
Table 8-3 lists the sensitive and nonsensitive CP6100 SCF commands.
Wild-Card Support
The CP6100 subsystem does not support any wild-card notation.
Time Values
The variable time is used for modifiers that require a time interval to be specified. The
syntax of time is:
where HH is an integer that specifies hours, MM is an integer that specifies minutes, SS
is an integer that specifies seconds, and hh is an integer that specifies hundredths of a
second. The modifier descriptions provide the range of values that are valid for that
modifier.
In displays generated by the STATS command, HH is an integer in the range 0 through
23. MM and SS are integers in the range 0 through 59. hh is an integer in the range 0
through 99. For example, 5:27.02 is 5 minutes, 27 seconds, and 2 hundredths of a
second.
Table 8-3. Sensitive and Nonsensitive CP6100 SCF Commands
Sensitive Commands Nonsensitive Commands
ABORT INFO
ACTIVATE STATS (without the RESET option)
ALTER STATUS
START VERSION
STATS (with the RESET option)
STOP
SUSPEND
SWITCH
TRACE
HH.MM.SS.hh