CP6100 Configuration and Management Manual

Managing CP6100 Using the Subsystem

Control Facility (SCF)

CP6100 Configuration and Management Manual—426741-003

8-15

Command Syntax for the INFO Command

The INFO command has the following syntax:

OUT file-spec

causes any SCF output generated for this command to be directed to the specified

file.

LINE line-name

specifies information for a particular line. If you omit line-name, SCF displays the

modifier values for the assumed line (see the SCF Reference Manual for G-Series

RVUs or SCF Reference Manual for H-Series RVUs for details about the

ASSUME command).

DETAIL

causes detailed information to be displayed. If you omit DETAIL, you see only one

line of information for each object.

Display for the INFO LINE Command

The format of the display for the INFO LINE command without the DETAIL option is

shown below. Alterable modifiers are denoted with an asterisk. Refer to the applicable

protocol section of this manual, for detailed descriptions of these modifiers.

Name

is the name of the LINE object.

Opclass

is the communications interface type for the line.

Program Name

is the communications line interface processor (CLIP) download program filename.

INFO [ /OUT file-spec / ] [ LINE line-name ] [ , DETAIL ]

CP6100 INFO LINE

Name *Opclass *Program Name

$CPA1 BITSYNC $SYSTEM.CSS01.C8169P00