CP6100 Configuration and Management Manual

Managing CP6100 Using the Subsystem
Control Facility (SCF)
CP6100 Configuration and Management Manual—426741-003
8-19
INFO LINE Command Display for the MPSB
Subtype
INFO LINE Command Display for the MPSB Subtype
The format of the display for the INFO LINE command for the MPSB subtype with the
DETAIL option is shown below. Alterable modifiers are denoted with an asterisk. Refer
to the applicable protocol section of this manual, for detailed descriptions of these
modifiers.
Considerations for the INFO Command
•
The SUB, SEL, DEFAULT, and ATTR-NAME options are not supported.
•
The information that you receive depends upon the line protocol that you use.
•
INFO is rejected with an error if the line is in the DIAGNOSING state.
•
INFO is rejected with an error if AUTOCONF is not set.
•
If the line is stopped, INFO displays the values in the template block maintained by
CP6100.
•
If the line is started, INFO displays values from the configuration block in the CLIP.
CP6100 DETAIL INFO LINE $CPM4
*Opclass...........ASYNC
*Program...........$SYSTEM.CSS01.C9314P00
Type/Subtype......(51,4) Protocolid...........15
MPSB INFO
*Line Type.........HALF^DUPLEX *Switched............NO
Alter Attr Set....MPSB
*Control CF........NO *Parity..............EVEN
*Baud..............1200
*Conn Timeout......3000 *Timeout.............270
*Retries...........3 *Nonstop.............ON
*Poll Interval.....0 *Pace................0
*Syncs.............0 *Char Size...........7
*Auto Disable......NO