CP6100 Configuration and Management Manual

Managing CP6100 Using the Subsystem
Control Facility (SCF)
CP6100 Configuration and Management Manual—426741-003
8-22
Display for the STATS LINE Command
Display for the STATS LINE Command
The display for the STATS LINE command has the following format:
The statistics are described below. The information listed in the statistics display
applies only after the last RESET and/or cold start.
ResetTime
is the date and time that the last reset operation was performed.
SampleTime
is the date and time at which this sample of statistics was taken.
Total Frames
is the number of frames that were sent from and received for the specified line.
Frame Errors
is the number of frame errors that occurred at the CIU-to-LIU bus (CLB) level for
the specified line.
Pool Size
is the size of the local pool.
Max Usage
is the maximum pool usage in bytes at any point.
Status Probe Errors
is the number of status probe errors.
CP6100 DETAIL STATS LINE $CPT5
ResetTime....... 13 JUN 1995, 16:32:10.866
SampleTime...... 16 JUN 1995, 10:49:17.936
Total Frames..........47734 BCC Errors..............0
Frame Errors..........0
Pool Size.............55098 Current Usage...........414
Max Usage.............450 Pool Fails..............0
Status Probe Errors...0 Line Errors.............0
No Buffer Errors......0 Buffer Too Big Errors...0
Invalid Fun Errors....0 Line Overruns...........0
Modem Errors..........0 CLIP Path Errors........0
Input Msgs............23867 Output
Msgs.............23867
Input Errors..........0 Output Errors...........0