CP6100 Configuration and Management Manual

CP6100 Subsystem Error Messages
CP6100 Configuration and Management Manual—426741-003
A-2
About CP6100 Errors
About CP6100 Errors
Each error listed includes a description of the probable cause of the error condition, an
explanation of the effect of the error, and a recommended recovery action. Error
messages are listed in numerical order.
The user can receive error messages through SCF. The messages are generated by
the file system, Subsystem Control Point (SCP), and so on. File-system, SCP, and
other errors originating outside the SCF environment are described in the
documentation supporting the particular source of the error and are not listed in this
manual. For information about trace-related errors, see the PTrace Reference Manual.
Some CP6100 error messages are not easily recoverable and require you to seek
additional help. In these cases, you should follow the standard procedures at your site
for contacting the appropriate support personnel. These procedures might involve
contacting the local Global Customer Support Center (GCSC) or your support
representative.
Before contacting your support representative, it is recommended that you collect any
relevant information (including the details from the error message), supporting
documentation (such as Event Management Service [EMS] logs), and a description of
the problem and the accompanying symptoms, so that you can provide the data to
support personnel. If your local operating procedures require contacting the GCSC,
please supply your system name and the numbers on versions of all related products
as well.
CP6100 Error 00001
Cause. The TRACE backup command was rejected because the current process is
not primary, or the backup process does not exist, or the current process is unable to
communicate with the backup process.
Effect. The TRACE command is not performed.
Recovery. Check that the backup process is up and then retry the command. Use the
STATUS LINE command to check that the backup process is up.
CP6100 Error 00002
Cause. The function code specified in TRACE command is incorrect.
Effect. The TRACE command is not performed.
Recovery. Check that the correct function code is specified.
CP6100 00001 TRACE backup command rejected; backup process is
not available.
CP6100 00002 TRACE command rejected due to undefined function
code in trace work struct.