CP6100 Configuration and Management Manual

CP6100 Subsystem Error Messages

CP6100 Configuration and Management Manual—426741-003

A-3

CP6100 Error 00003

Cause. The START command was rejected because of a CSM download error. The

error might be caused by an improperly downloaded file.

Effect. The specified line is not started.

Recovery. Check that the downloaded file is correct.

CP6100 Error 00004

Cause. The ABORT or STOP command was rejected because of a CLIP error.

Effect. The specified line is not stopped.

Recovery. Check the status and statistics of the line for any errors.

CP6100 Error 00005

Cause. The modifer set specified for the ALTER LINE command does not match the

subtype of the line.

Effect. The modifers are not changed to the new values that were entered.

Recovery. Use the INFO LINE command to get the correct modifer set and then use

the ALTER LINE command again.

CP6100 Error 00006

Cause. For the specified LINE, the NOAUTOCONF modifier is set.

Effect. The INFO LINE command does not display the configuration. The ALTER LINE

command does not alter the modifers.

Recovery. Set the AUTOCONF modifier and then execute the command.

CP6100 00003 START LINE command failed due to CSM download

error.

CP6100 00004 STOP LINE command was rejected due to CLIP

error.

CP6100 00005 Attribute set specified for ALTER LINE command

conflicts with device subtype.

CP6100 00006 ALTER/INFO LINE command rejected because

AUTOCONF modifier is not set.