CP6100 Configuration and Management Manual

CP6100 Subsystem Error Messages

CP6100 Configuration and Management Manual—426741-003

A-4

CP6100 Error 00007

Cause. The ADCCP modifier TRANSLATE should be ON for SNAXLATE to be turned

on.

Effect. The modifer is not altered.

Recovery. Use the ALTER command to set TRANSLATE and SNAXLATE to ON.

CP6100 Error 00008

Cause. The baud modifer is valid only if INTERNALCLK is set to YES.

Effect. The baud rate is not altered.

Recovery. Use the ALTER command to set INTERNALCLK to YES and specify the

baud rate.

CP6100 Error 00009

Cause. The LINE is OPEN.

Effect. The line is not stopped.

Recovery. Close the line and issue the STOP command, or use the ABORT

command.

CP6100 Error 00011

Cause. In an ALTER command, the specified value of the modifer was incorrect.

Effect. The modifer is not altered.

Recovery. Specify the correct modifer value and retry the ALTER command.

CP6100 00007 ALTER LINE, ADCCP SNAXLATE is being turned ON

when TRANSLATE is OFF.

CP6100 00008 ALTER LINE, BSC INTERNALCLK should be set to YES

for baud rate to be specified. If INTERNALCLK is set to NO,

baud rate cannot be specified.

CP6100 00009 STOP LINE command failed because line is OPEN.

Line cannot be stopped when it is open.

CP6100 00011 Alter command rejected because of invalid

attribute value.