CP6100 Configuration and Management Manual

Moving to G-Series or H-Series RVUs
CP6100 Configuration and Management Manual—426741-003
C-3
COUP-to-SCF Considerations
For more information about creating profiles, see the WAN Subsystem Configuration
and Management Manual.
COUP-to-SCF Considerations
The COUP interface is no longer supported for G-series or H-series RVUs. The COUP
functions are replaced by SCF. Although most COUP commands have a direct SCF
equivalent, the method of configuration for G-series or H-series RVUs is very different
from D-series RVUs. Refer to the SCF reference manuals listed in “About This Manual”
for more information.
The following list indicates the COUP commands that have no SCF equivalent and
cannot be used with G-series RVUs:
Managing CP6100 Lines
The Peripheral Utility Program (PUP), Dynamic System Configuration (DSC), and
ViewPoint Console application of Distributed Systems Management (DSM) are not
supported on G-series RVUs. The Subsystem Control Facility (SCF) replaces all of
these for G-series and H-series RVUs.
For NonStop S-series systems, Compaq TSM replaced the system maintenance
functions provided by the Syshealth toolkit, the HP Tandem Maintenance and
Diagnostic Subsystem (TMDS), and the Remote Maintenance Interface (RMI) product.
For more information about TSM, see the TSM Online Users Guide.
MPSB PCP6MPSB
TINET Not Supported
LIU PCP6LIU
CONFIG
INFO CONTROLLER
INFO
MF_CONTROLLERS
INFO PATH
RESET
SHOW
TIME
Note. TSM is not supported on NonStop NS-series servers. OSM is the supported system
management tool for NonStop NS-series servers.
Table C-2. CP6100 Macro and Profile Correlations
D-Series Macros G-Series or H-Series Profiles