CP6100 Configuration and Management Manual

ADCCP Protocol and Modifiers

CP6100 Configuration and Management Manual—426741-003

4-4

ADCCP Modifiers

ARMMODE

See ABMMODE, ARMMODE, or NRMMODE on page 4-2.

AUTOCLOSE

This modifier specifies that CP6100 CAP will CLOSE all file system OPENs if the CLIP

must be downloaded for error-recovery.

AUTOCONF

This modifier causes the CP6100 line-handler process to send the current

configuration block to the line interface unit (LIU) on the first OPEN (that is, when

OPEN count goes from 0 to 1) after a download.

AUTOLOAD

This modifier specifies that the CLIP software is to be automatically downloaded if the

CLIP sends a STATUS PROBE message with a status error greater than 1.

BITSYNC

This modifier is an operational class modifier that specifies the operational class of the

LIU download module as bit-synchronous. If an appropriate module is not found in the

Default: AUTOCLOSE

Units: None

See

also:

NOAUTOCLOSE

Default: AUTOCONF

Units: None

Range: N/A

See

also:

NOAUTOCONF on page 4-10

Default: AUTOLOAD

Units: None

See

also:

NOAUTOLOAD

Note. AUTOLOAD will prevent you from obtaining a CLIP dump if the CLIP crashes, because

the autoload will occur before the dump can be obtained.

Default: BITSYNC

Units: None