CP6100 Configuration and Management Manual

ADCCP Protocol and Modifiers
CP6100 Configuration and Management Manual—426741-003
4-5
ADCCP Modifiers
download file, the operation terminates. BITSYNC is the default operational class for
the PCP6ADCP profile.
When the BITSYNC modifier is included in the PROFILE file, the ConMgr process
checks to make sure that the operational modifier specified in the microcode file
matches the line configuration. If they do not match, the microcode download does not
occur; however, you will not receive an SCF error. If the operational modifier does not
match the line configuration, you will receive a system error stating that the microcode
was not downloaded after the attempted download to the CLIP.
CLBFRAMESIZE n
This modifier changes the framesize sent to the CLIP. The value n specifies the
maximum number of words to be transferred in a frame.
If you specify a value larger than the range, the software changes the value to the
maximum allowed. Likewise, if you specify a value smaller than the range, the software
uses the minimum value.
CLBRETIRES n
This modifier specifies the number of retires for requests. The value n is the number of
tries.
CLBTIMEOUT n
This modifier specifies the timeout. The value n is the length of time before a timeout
occurs.
Default: 256
Units: Words
Range: 150 through 600
See
also:
CLIPTRACEREC n on page 4-6
Default: 4
Units: None
Range: 0 through 63
Default: 3000
Units: 0.01 seconds
Range: 0 through 32767