CP6100 Configuration and Management Manual

ADCCP Protocol and Modifiers
CP6100 Configuration and Management Manual—426741-003
4-13
ADCCP Modifiers
RSIZE 80
This modifier specifies the record length in bytes, which is always 80 bytes for CP6100.
SNAXLATE
This modifier specifies that the TRANSLATE modifier is on and that the requester not
ready (RNR) timer for SNA is set to 255 seconds. By default, SNAXLATE is off.
SREJ
This modifier specifies that selective reject (SREJ) frames are to be transmitted and
received. By default, SREJ frames are not transmitted, and the reception of an SREJ
frame results in transmission of a FRMR frame.
STARTBOOT
This modifier specifies that when the system is cold-started, the LIU is not downloaded
automatically but rather is left in the boot state. You can use SCF to load and start the
LIU. If you specify this modifier you must also specify STARTDOWN.
Default: None
Units: Bytes
Range: N/A
Default: No SNAX translation
Units: None
Range: N/A
See
also:
TRANSLATE on page 4-16
Default: SREJ not supported
Units: None
Range: N/A
Default: None
Units: None
Range: N/A
See
also:
STARTDOWN on page 4-14