CP6100 Configuration and Management Manual

CP6100 Configuration and Management Manual—426741-003
5-1
5 BSC Protocol and Modifiers
This section gives a brief overview of the BSC protocol and describes the modifiers
that you can use to modify the functioning of a BSC communications line.
PCP6BSC Profile
The PCP6BSC profile configures the line for the Binary Synchronous Communications
(BSC) protocol. The BSC protocol provides for two-way alternate transmission over
half- or full-duplex lines and provides for the use of leased or switched facilities.
Table 5-1 lists the default modifiers and values for the PCP6BSC profile provided by
HP.
Note. The PCP6BSC profile is used to configure CP6100 for BSC point-to-point operation.
For multipoint BSC-Supervisory or BSC-Tributary protocols, you must use the corresponding
protocol download module (DLM) and the PCP6LIU profile.
Table 5-1. PCP6BSC Default Modifiers and Values
Modifier Default Value Modifier Default Value
AUTOCONF TIMEOUT 3000
AUTOLOAD
RETRIES 3
AUTOCLOSE CLIPTRACEREC 80
MAXLOCALAREA 8200 CONFIGSIZE 11
LOCALPOOLPAGES 60 BSCHALF
CLBFRAMESIZE 128 BSCPPNSW
CMGLDEV 0 BSCCONNECTTO 3000
BYTSYNC BSCDISCONNECTTO
50
PROGRAM C1095P00 BSCNONSTOPOFF
TESTINT 1000 BSCSYNCS 3
CLBRETRIES 4 BSCREADTO 3000
CLBWINDOW 1 BSCRETRIES 7
CLBTIMEOUT 3000 BSCITBSIZE 0
PROFILE Depends on IPM