CP6100 Configuration and Management Manual

BSC Protocol and Modifiers

CP6100 Configuration and Management Manual—426741-003

5-2

BSC Modifiers

This subsection describes each modifier contained in the PCP6BSC profile and all

other modifiers that can be used with the BSC protocol. For detailed information on

using the Subsystem Control Facility (SCF) to alter the default values for the duration

of the current session, refer to Section 8, Managing CP6100 Using the Subsystem

Control Facility (SCF). For detailed information on permanently altering the modifier

default values contained in the PCP6BSC profile or creating a new profile, refer to the

WAN Subsystem Configuration and Management Manual.

AUTOCLOSE

This modifier specifies that CP6100 CAP will CLOSE all file system OPENs if the CLIP

must be downloaded for error-recovery.

AUTOCONF

This modifier causes the CP6100 line-handler process to send the current

configuration block to the line interface unit (LIU) on the first OPEN (that is, when

OPEN count goes from 0 to 1) after a download.

AUTOLOAD

This modifier specifies that the CLIP software is to be automatically downloaded if the

CLIP sends a STATUS PROBE message with a status error greater than 1.

Default: AUTOCLOSE

Units: None

See

also:

NOAUTOCLOSE

Default: AUTOCONF

Units: None

Range: N/A

See

also:

NOAUTOCONF on page 5-12

Default: AUTOLOAD

Units: None

See

also:

NOAUTOLOAD

Note. AUTOLOAD will prevent you from obtaining a CLIP dump if the CLIP crashes, because

the autoload will occur before the dump can be obtained.