CP6100 Configuration and Management Manual

BSC Protocol and Modifiers
CP6100 Configuration and Management Manual—426741-003
5-6
BSC Modifiers
BSCLRC8
This modifier specifies that LRC is used for the FCS. By default, this modifier is not in
effect (that is, CRC16 is used for the FCS). BSCLRC8 can be used only with ASCII
code.
BSCNONSTOPOFF
This modifier disables the fault-tolerant processing in the CLIP. That is, the application
must either treat path errors as fatal or do end-to-end recovery. This is discussed in
more detail in the 6100 BSC Programming Manual.
BSCNONSTOPON
This modifier enables the fault-tolerant processing in the CLIP. That is, the application
may do simple retries to recover from path errors.
BSCPPNSW
This modifier specifies a nonswitched (leased) line. For leased lines, DTR remains on
at all times.
Default: Frame-checking sequence (FCS) is CRC16
Units: None
Range: N/A
Default: BSCNONSTOPOFF
Units: None
Range: N/A
See
also:
BSCNONSTOPON on page 5-6
Default: BSCNONSTOPOFF
Units: None
Range: N/A
Default: BSCPPNSW
Units: None
Range: N/A
See
also:
BSCPPSW on page 5-7