CP6100 Configuration and Management Manual

MPS-B Protocol and Modifiers
CP6100 Configuration and Management Manual—426741-003
6-2
MPS-B Modifiers
using the Subsystem Control Facility (SCF) to alter the default values for the duration
of the current session, refer to Section 8, Managing CP6100 Using the Subsystem
Control Facility (SCF). For detailed information on permanently altering the modifier
default values contained in the PCP6MPSB profile or creating a new profile, refer to
the WAN Subsystem Configuration and Management Manual.
ASYNC
This modifier is an operational class modifier that specifies the operational class of the
LIU download module as asynchronous. If an appropriate module is not found in the
download file, the operation terminates. ASYNC is the default operational class for the
PCP6MPSB profile.
When the ASYNC modifier is included in the PROFILE file, the ConMgr process
checks to make sure that the operational modifier specified in the microcode file
matches the line configuration. If they do not match, the microcode download does not
occur; however, you will not receive an SCF error. If the operational modifier does not
match the line configuration, you will receive a system error stating that the microcode
was not downloaded after the attempted download to the CLIP.
AUTOCLOSE
This modifier specifies that CP6100 CAP will CLOSE all file system OPENs if the CLIP
must be downloaded for error-recovery.
AUTOCONF
This modifier causes the CP6100 line-handler process to send the current
configuration block to the line interface unit (LIU) on the first OPEN (that is, when
OPEN count goes from 0 to 1) after a download.
Default: ASYNC
Units: None
Default: AUTOCLOSE
Units: None
See
also:
NOAUTOCLOSE
Default: AUTOCONF
Units: None
Range: N/A
See
also:
NOAUTOCONF on page 6-12