CP6100 Configuration and Management Manual

LIU Protocol and Modifiers
CP6100 Configuration and Management Manual—426741-003
7-6
LIU Modifiers
CLIPTRACEREC n
This modifier specifies the maximum number of bytes to be placed in an LIU trace
record. The CLIPTRACEREC value may not exceed CLBFRAMESIZE. Any attempt to
exceed this value results in CLIPTRACEREC being limited automatically to the same
value as CLBFRAMESIZE.
CMGLDEV
This modifier specifies the CONMgr logical device ID and should not be altered.
CONFIGSIZE n
This modifier specifies the length of the configuration block to be sent after download if
the AUTOCONF modifier has been specified.
Default: 32
Units: Bytes
Range: 16 through 256
See
also:
CLBFRAMESIZE n on page 7-5
Default: SWAN concentrator
Units: 0
Default: 20
Units: Words
Range: 1 through 20
See
also:
AUTOCONF on page 7-3
Note. You must use a SETCONFIG request to configure CP6100 for the Generalized Full
Duplex (GFDX) protocol because the GFDX configuration block is too large for the
CONFIGSIZE modifier.