CP6100 Configuration and Management Manual

CP6100 Configuration and Management Manual—426741-003
8-1
8
Managing CP6100 Using the
Subsystem Control Facility (SCF)
This section describes the Subsystem Control Facility (SCF) interface to the CP6100
subsystem and provides SCF command syntax. Depending on your RVU, refer to the
SCF Reference Manual for G-Series RVUs or the SCF Reference Manual for G-Series
RVUs for general information about running SCF.
Topics described in this section include the following:
•
Overview of the CP6100 Subsystem SCF Interface on page 8-2
•
ABORT Command on page 8-8
•
ACTIVATE Command on page 8-9
•
ALTER Command on page 8-10
•
INFO Command on page 8-14
•
START Command on page 8-20
•
STATS Command on page 8-21
•
STATUS Command on page 8-25
•
STOP Command on page 8-28
•
SUSPEND Command on page 8-29
•
SWITCH Command on page 8-30
•
TRACE Command on page 8-31
•
VERSION Command on page 8-34
Note. Modifiers specific to each protocol supported by CP6100 are described in the
following sections:
•
Section 4, ADCCP Protocol and Modifiers
•
Section 5, BSC Protocol and Modifiers
•
Section 6, MPS-B Protocol and Modifiers
•
Section 7, LIU Protocol and Modifiers