CROSSREF Manual

WARNING AND ERROR MESSAGES
Error Messages
ERROR MESSAGES
Error messages indicate that CROSSREF is unable to execute a
command for some reason. You must correct the situation before
CROSSREF can execute the command.
Error messages are either prefixed with "**** ERROR ****" or
displayed exactly as shown in this appendix.
Compiler Communication Lost
Cause: The compiler process halted for some reason. CROSSREF
also generates this message when the processor running
the compiler fails.
Recovery: Examine the compiler error file with the ERRORS
command.
Crossref: Compiler version not compatible
Cause: CROSSREF attempted to run an invalid version of the
compiler. If you did not set the PROGRAM attribute
specification, then the version of the compiler on
the system and volume that you are using was not
updated to run with CROSSREF. If you did set the
PROGRAM attribute specification, then the compiler you
specified is not compatible with CROSSREF.
Recovery: Either update the compiler on $SYSTEM.SYSTEM, or
specify a valid version of the compiler in the PROGRAM
attribute specification.
B-3