DAT 72 (Models 5242 and 5242ACL) Tape Drive User's Guide

Section 3: HP 5242-ACL Tape Drive
Clean Me Error Flashing A high error rate has been
detected reading or writing.
Insert a cleaning
cartridge to clean the
tape heads.
Config: xxy
Note:
For the
5242ACL
xxy is
factory
configured
at "FF1"
Info This indicates the value of
the switches used to
configure the drive for
different host systems. xx
is the hexadecimal value of
the Configuration Switches
on the underside of the
autoloader, and y the value
of the Autoloader Option
Switches on the rear panel.
During the power-up
sequence, it is displayed
for 2 seconds following the
SCSI ID.
Close Door Error Flashing The front panel door is
open. Any autoloader
motion will be delayed.
Probably a magazine
that is partially inserted
through the door. Push
the magazine fully in
or remove it.
Drive
Comms
Error
Error On The drive has stopped
communicating with the
changer mechanism.
Contact the HP GCSC.
Eject Fail Error Flashing An eject command has
failed, either after you
pressed the Eject button or
after a host command.
Try forcing ejection.
Eject Mag Info This is displayed when you
press the Eject button.
Error X Error Flashing The mechanism has
jammed. X gives the
reason for the jam.
Press the Eject button
to attempt to recover
cartridge and
magazine. If the
problem persists, note
the value of X and call
the HP GCSC.
ForceEject Info A forced ejection is in
progress.
Format Status A SCSI command for
generating a one- or two-
partition tape is being
executed, or the drive is
changing the size of the
partitions on an existing
two-partition tape.
HP StorageWorks DAT 72 (Models 5242 and 5242-ACL) User's Guide 42 HP Part Number 528296-03 July 2005