Data Build Manual

Changed Information
New and Changed Information
iv 099331 Tandem Computers Incorporated
Changed Information The following table summarizes the minor changes made to the product since the last
release of the manual.
Change Description Section
Tape DEFINE A tape DEFINE is included in the DEFINES and
PATHCNFG files.
Section 2
Error handling
improved
Data Build now displays each tape input error, and you can
control how many errors to tolerate before ending.
Section 2
Purging an
existing project
subvolume
Data Build purges all files on an existing project subvolume
when you run Project. In the C30.08 release, Data Build
purged only files that matched the new files being created.
Section 3
Exiting the
Project utility
You can exit the Project utility at any time by entering END
at any prompt.
Section 3
Changing
responses in
Project utility
You can selectively change responses to the Project utility
by entering N(o) when asked if you want to proceed.
Section 3
COMP and
COMP-3
equivalents
COMPUTATIONAL or COMP and COMPUTATIONAL-3 or
COMP-3 are valid equivalents in the Source Record
Descriptions file; previously only COMP and COMP-3 were
valid.
Section 3
Direct access to
DDL, FUP, and
SQLCI
Data Build now provides direct function key access to DDL
(F8), FUP (F9) and SQLCI (F11).
Section 7
Options for
Configure field
You can now enter Enscribe in the Option 1 field on the
Conversion Environment screen instead of leaving the
Option 1 field blank.
Section 7
Printing the
screen
You can press F5 from the Configure screen to print the
screen.
Section 7
ZZRESRVD file This file only applies to IXF input Appendix E