Data Transformation Engine Execution Commands Reference Guide

Chapter 2 - Execution Commands List of Execution Commands
Execution Commands Reference Guide
15
MapAudit (-A)
Use the MapAudit execution command (-A) to control the creation of audit log
information. Using this command, audit information is recorded which can include
data audit information and execution audit information.
When used with other specified options, the MapAudit settings specified with the
MapAudit command (
-A) override all MapAudit settings compiled into the map.
When used without other specified options, no audit log is produced.
-A[D[R|W]{1|2}][E[R|W]][B[R|W]][C[R|W]][P[R|W]]
[M[S]|[U][+|!+][={
file | dir }]]
For information about the audit log files, refer to the Map Designer Reference
Guide.
Option Description
D
Include data audit information in the audit log. The recorded
information is based on the MapAudit settings configured in the
Map Designer for a particular map.
The sub-options for
D include: R, W, and 1 or 2
R
Generate audit files each time the map is run only if the outcome
of the map's execution is an error condition.
Used with the burst audit data information (D), execution summary
audit information (E), burst execution information (B), card (data)
settings (C), and map settings (P) options.
W
Generate audit files each time the map is run only if the outcome
of the map's execution is a warning or an error condition.
Used with the burst audit data information (
D), execution summary
audit information (
E), burst execution information (B), card (data)
settings (
C), and map settings (P) options.