Data Transformation Engine Execution Commands Reference Guide

Chapter 2 - Execution Commands List of Execution Commands
Execution Commands Reference Guide
29
Option Description
W
After a map runs the first time, the WorkArea created for
the input card is not deleted. For subsequent executions
of the same map, the data for this input card is not
validated and the WorkArea information for the card is
retrieved from the existing WorkArea.
!W
The WorkArea of the input is created when map execution
begins.
X
If the map, burst, or card completes successfully, the
input data file is deleted.
X0
If the map, burst or card completes successfully, the input
data file is deleted only if it has no content (it is zero
bytes).
Note If neither of the delete options (X or X0) is
specified, the OnSuccess setting compiled into the
map is used.
R count:interval
Specify Retry settings. If the source is unavailable, the
adapter attempts to access the source as many times as
specified by the count setting at the interval specified by
the interval setting.
count number of attempts to access the data file
interval number of seconds to wait between attempts
Note If this option is not specified, the Retry settings
compiled into the map are used. To eliminate
adapter retry, specify R0:0.
B
If the map, burst, or card does not complete successfully,
roll back any changes made to this data source. If this
option is not specified, the OnFailure setting compiled
into the map is used.
K
When the map, burst, or card runs, no backup file will be
created.