Data Transformation Engine IBM WebSphere MQ Adapter Reference Guide

Chapter 2 - Command Aliases PUT > Target Settings
IBM WebSphere MQ Adapter Reference Guide
12
Value Description
Card Check for success or failure at the completion of each card. If the card
is successfully processed, use the OnSuccess setting. If the card fails,
use the OnFailure setting.
Source > Transaction > Warnings Setting
Use the Warnings setting to determine whether to fail the map or ignore warning
conditions for the specific input map card. The warning messages are written to
the execution audit log. The default value is Ignore.
Value Description
Ignore Ignore warnings for this map card.
Fail Fail the map upon receiving a warning for this map card.
Note Warning messages have a positive return code.
PUT > Target Settings
Use the Map Designer PUT settings to configure options for output map cards that
use the IBM WebSphere MQ (client) or IBM WebSphere MQ (server) adapters. Use
the PUT > Target setting to select the data target. Select MQSeries (client) or
MQSeries (server) to use the IBM WebSphere MQ adapters.
PUT > Target > Command Setting
Use the PUT > Target > Command setting to enter adapter commands. For
command syntax, refer to List of Commands.
Target > Transaction > OnSuccess Setting
Use the OnSuccess setting with adapter targets to prevent a message from being
unnecessarily created during any processes. The default value is Create.
Value Description
Create Upon successful completion of the burst, map, card, or rule
(determined by Scope settings), send the message.